Improvements and corrections in Powerpack
See Release notes for Noise Powerpack.

Check profile
While selecting points for “Check profile”, you can write “l” (small “L”) instead of choosing a point. The function will then use the same point as last time, even if the drawing has been closed and reopened.

Selecting many objects in a dialog box
If you use selection buttons resulting in more than 255 objects being selected, you no longer receive error messages from AutoCAD. The list will still be greyed out and no direct selection in the list is possible. But all buttons to handle the selected objects work. You could e.g. press “Select all” and “Passive” to set all objects passive, no matter how many there are in the list.

Barrier width
Barriers where drawn with half width. This had little influence on calculated values, but gave a wrong visual representation. Old drawings will be automatically updated when opened.

Wrong placement of traffic data when start profile was different than 0
If you changed the start profile for a road to anything but 0, the markings of where traffic data changed, where incorrectly placed along the road. This did not affect calculations. The error is corrected.

For existing drawings with this error, you can simply enter the dialog for traffic data for the road and press “OK” to update the placements correctly.

Problems editing traffic data when start profile was less than 0
If you had set start profile for a road to less than 0, problems editing traffic data arised.

Crash when selecting in dialog box
If buttons to select very many (several thousand) objects in a dialog box where used, you could get a crash after a message about “Capacity of tile XX exceeded”.