NP18.00FP1c

The test function vnnp_noiseplinejoin has had some improvements. See vnnp_noiseplinejoin.

During the function Fetch buildings the buildings where automatically assigned a ridge if there was any inside the building polyline. The program picked the first ridge line found. This functionality is now improved to pipick the longest available ridge, which normally will give a better representation of the building.

When calculating in triangle models, the program could crash on calculation of long profiles. The limit was 2.000 points during PowerPack calculations and 4.000 points during direct calculation in AutoCAD.

These limits are now increased to 10.000 points in both calculation types.

Check profile does not work
When you run the command Check profile, sometimes there is no result at first attempt, only an error message Error in profiling. If you run the same command once more with the same points, normally things are ok. If it fails all the time, try increasing the search distance in Global settings.

This error seems to cause no real problems and has no consequence for calculations. It is also difficult to reproduce consequently. It will therefore not be prioritized for correction. If there are complaints about this error causing big problems, we will reconsider this decision.