Draw Road Elevation Annotations

Use this function to draw elevation annotations along selected surfaces.

• These annotations can be drawn for desired section of the road model.
• These annotations will be inserted at the interval used for road surface calculations.
• The elevations will be read from the active road project.
• Primary requirement for this function is that, road surface calculations are performed in the module 'Road Design'.
• These elevations of the road surfaces are very useful for intersection design.

Run the from the following locations:

Toolbar: Draw Road Elevation Annotations
Menu: Road > Draw Road Elevation Annotations…

The dialog 'Draw Road Elevation Annotations' will pop up.

• Project ID: The active road model and the active Quadri line identity will be displayed.
  • The dialog 'Novapoint Project Settings' will pop up with the button 'Project ID', which enable to set desired project/model active.
  • For further details on, refer the topic 'Project ID'.
• From/To Chainage: The road model's first chainage and last chainage will be displayed.
  • By default, elevation annotations will be drawn for the entire section of road model.
  • In case, annotation not required for the entire section, define the section at these fields.

• Mark the check box to refresh the list.

• The elevation annotations can be drawn either outside or inside the surface.
• Mark the desired radio button.

• Annotations can be inserted either at the respective elevations of the surface points or at elevation of the drawing file (AutoCAD command 'Elevation').
• Mark the desired radio button.
• The label consists of a line and text.
• The mid point of the line represents the road surface point and the text represents the elevation.

• All the road surfaces used in the road model will be displayed.
• Select the desired surfaces, for which elevation annotations are to be drawn.
• Multiple surfaces can be selected using the key 'Ctrl' or 'Shift'.

E.g.: Result of the function.